Flexplate install tricks?

All of the other three bolts/holes started perfectly. Then got to the last one and no go. I even took all of them back out and tried to start bolt/hole #4 by itself. It wouldn't even start without any of the others in yet. I tried turning the TQ to all different positions. The holes were half of a hole off, which is what I expected. TurboAction stamped an X in the housing, presumably where the gap in the flexplate should go. So after 5 hours of monkeying with it, and 100 miles or so worth of crank turns, it was obvious that the only way it was going to work was to bump it with a die grinder. All it took was about .030" on the one side and it finally went. I am guessing the spacer block on the TQ was just out of tolerance. Think I will have any issues?