[WANTED] Rocker molding clips
- Thread starter downsr
- Start date
-
- Status
dano
Evil Handy Man
Have you tried Mr G's? It's where i got the ones for my 69.
https://mrgusa.com/
Go to "Fasteners" and download the "clips" pdf's and see if there is one that looks the same then call them.
https://mrgusa.com/
Go to "Fasteners" and download the "clips" pdf's and see if there is one that looks the same then call them.
I did order FA468. My clips are for a 1968 Dart rocker (sill) molding. The small Plastic clips shown look exactly like the ones I need. I destroyed a few before I figure out how they work. We must be looking for different clips.
grimreaper
Cross Member
Have you tried the guys at Restoration Specialties? They are my "go to" for unusual clips and doodads. http://www.restorationspecialties.com/ If you don't see it give 'em a phone call.
340sFastback
Well-Known Member
True but not many '69s were built with the moldings. Early Scamps use the same molding clip as a Duster (2" wide) but the Scamp is a longer wheel base so the molding itself is not interchangeable with a Duster. But if you are trying to locate used clips put Scamp on your list of cars to look out for.
ir3333
Well-Known Member
this is the clip for the Duster 1 3/4" moulding.
the moulding has a blind bolt at the front that goes through the rocker and is captured by a nut inside the wheel well.
..with that tightened these could be made out of sheet stock just wide enough to slide on and catch the outside edges of the moulding along the rocker.About 7 or 8 pieces should do it.
the moulding has a blind bolt at the front that goes through the rocker and is captured by a nut inside the wheel well.
..with that tightened these could be made out of sheet stock just wide enough to slide on and catch the outside edges of the moulding along the rocker.About 7 or 8 pieces should do it.
- Status
-
