How to remove outer wheelhouse?

HemiOrangeSwinger,
that really helps. Now that I look at it closer, I can feel the 1/8 weld seam. Wow, there is a lot of stuff in the way to remove the old seam. I am not sure which way to go now.

I get a little nervous doing your way for two reasons. 1. have to be really careful to get the opening in the exact location as the old one 2. that is a lot of but welding on thin sheet metal.

How did you ensure your wheel opening remained in the original location?



It might be better to use panel adhesive if going Danny's way. That would make a watertight seam. Just thinking.