Carb to Holley Terminator EFI Conversion How To w/lots of pics

Here are some progress pics of the fuel system. Had to ditch the old electric pump and bought the Aeromotive EFI pump (P/N: AE1-11106). I already had the Holley 100 micron fuel filter (P/N: 162-553) on the old setup so I am reusing it for this setup. I installed a -8an o-ring fitting on the inlet side and a -6an o-ring to -8an fitting on the outlet side of the fuel pump. I went to the local Lowes and bought some angle and flat steel stock to make the new brackets. I cut the old brackets off the fuel cell frame and welded in the new stuff. For the mounts I am going to weld studs to the new mounting plates as the pump setup will sit under the fuel cell. The fuel filter sits a little higher then the pump mounts so I am welding threaded couplers to the mount plates to compensate. I am still playing around with this so its not permanent yet. Just ran out of time as I wanted to spend time with the kiddos before I left.