340 Ring Gap Question...

mech1nxh said
With Respects Sir,

Could You post taper measurements Cyl To Cyl ?--
Dial bore gauge, or Telescoping Gauge & Mic measurements.

& The Ring MFGR?

<s>Thx !</s>

Here is the amount of taper that I had measure using a dial bore gauge.

1- .0013
2- .0018
3- .0006
4- .0012
5- .0012
6- .0014
7- .0013
8- .0010

As for the rings that I have. They are a low cost set of Hastings Moly Rings #694 Their installation instructions only address a minimum end gap concern.