electrical motor wizards

Picked up an older Craftsman drill press that runs on 110VAC. Stand and everything looks great. Problem is the motor doesn't run, just hear a click when you turn it on. I got it for $20. Friday, I took the belt off the motor and it spins freely and it will run with help, I spin it then turn it on. Today, Sunday, I went out and pulled the motor off, and split the case. There is a capacitor for starting the motor. No obvious signs of cap being bad, not bulging or smelly, no deformation. Now, how do I check this cap with a volt/ohm meter? I know I could just get another motor with the same rating as the one on there, but I like to tinker and if the cap is bad, why not just replace that? Thanks.