New cluster did not fix the dead Gauge issues HELP
Is this same as yours?
We'll flip it around, because it will then match the shop manual
Notice that the pin layout now matches the diagram
1...First pin of 5 is missing at far bottom left
2....Instrument lamp feed
3....Right turn indicator
4....Switched "ignition run" to power limiter
5....high beam indicator
FAR RIGHT CONNECTOR
6..."G4" to fuel sender
7...instrument lamps.
8...left turn indicator
9....blank
10...temp gauge sender
Go to the right, notice "oil pressure warning" notice it has TWO WIRES
G5 on left is switched ignition power "going to" lamp
G6 on right runs out through bulkhead to oil senderw
![](http://i59.tinypic.com/2u9jvoh.jpg)