My 360 is almost complete

Engine specs for the build;
Balanced and blueprinted short block
Windage tray
should be 9.00-1 or very close
Lunati streetmaster grind;Advertised Duration (Int/Exh): 266/266
Duration @ .050 (Int/Exh): 220/220
Gross Valve Lift (Int/Exh): .485/.485
LSA/ICL: 110/104
Valve Lash (Int/Exh): Hyd/Hyd
RPM Range: Idle-5500
MP 308 heads with 2.02 intake
Port matched edelbrock performer
Holley 650 spreadbore with vacuum secondary
Coated 1 5/8 long tubes
2.5 exhaust into single 3" using flowmaster Y-pipe
3" exhaust with magnaflow muffler exiting in stock location

Stock 727 and converter(from 318 engine)
8.25 2.71 peg leg but will be switched to 3.55 sure grip after break in of engine.

Don't know what to expect power wise but 350hp(flywheel) would be acceptable for me.

I built this using info from threads here and expect it to be a torque motor with some good mid range as well.This is my first mopar small block build after 30 years of big blocks.