Factory Rear Sway Bar

Ok so a completely different duster than previously mentioned I decided when I went to swap in an a body 8 3/4 with 3.55s I picked up to try and install the sway bar.

I assembled the rear with the sway bar and springs outside the car and then rolled it under.

The mounting plates successfully sandwiched between the perches and the springs. Without any form of an isolator bushing

I attempted to put it over the axle with no luck so it must mount underneath like I have it.

Now all I need to do is replace the bushings with polyurethane variants that I have just need to track down the ones that go around the bar... And cut the the holes in the frame rail and sleeve them so the rail is not crushed when bracket is tightened down.

One of the many parts to my slow progress on the build:burnout: