Espo Springs 'n Things install feedback ***

Then when we were putting the springs up, I had to put the shackle almost flat (parallel to the ground) to get it to line up enough to start the bolts. Normally when I use the MP supeer stock springs, they are at a 30° - 45° angle.


I was concerned about that, but after placing a jack under it and compressing it a little it was sitting ok.

Then when we finished the other one and lifted it up with the floor jack, the other spring shackle started moving forward and up instead of rearward... I had to lower the jack and then use a pry bar and re-jack it up to get it to go rearward like it's supposed to do.

I am concerned that it may want to go forward again if someone jacks it up by the frame and then tries to lower it without making sure it goes the proper direction. Maybe I'm wrong, I hope so...

But other than that, they are ok. They sit up nice in the rear and have a nice ride to them. The owner was happy with the end result.


I'm not going to say don't buy from Espo Springs 'n Things, go with them if you wish. I just wanted to let you know how some of the issues that we encountered to help you work through it if you do...


They were helpful when we called (at least 4 calls) and helped with our concerns and offered suggestions. They even called back within less than 10 minutes after leaving a message. I give them an "A" for customer support after the sale...