69 barracuda trunk seal issue

momoparman said
Yea I know its pretty generic and I understand they sell the same profile for several models.

Steele Rubber uses the same methods and materials as OEM so it works. PERIOD.

Additionally I would start the seal at the middle of the trunk instead of the side when you do the next one. If you need more tips let me know via PM. You tube is also laden with great tips.

Use only 3m black adhesive and have solvent ready for clean up.....but you may already know all of this. If so its a tip to everyone who did not know.

Good luck.

It was started in the center, I did not show that. The soft seal is sectioned and joined in the corners where the seal transistions from the sides to the bottom edge. It gets a little thinner there before it makes the turn. It is designed that way and that is where it stuck to the lid the most and started tearing apart. Forget what they call it, (maybe filleting). The seal is basically three pieces joined together during manufacturing.