Body help/advice needed

View attachment DSCN1880.jpg
Heres what I started with. Both sides needed repair and the patch panels you had to buy as 2 separate pieces.

View attachment DSCN2942.jpg
The guy that started the work wanted to use the original body line as the place to glue panel too. We used the 3m 8115 bond compound. he cut the old off 1 inch below the line then trimmed the new panel to match the original line. This gave us 1" for bonding. Where the 2 repair panels matched there is also 1" over hang for bonding.

View attachment DSCN2935.jpg
Here is a pic with the outer panel trimmed off and you can see how bad the inner fender was. I dont have to build a factory current inner as I need to have as much space as possible inside so my slicks dont hit inner so I told him we could bond the inner to the outer up in well if that would work. More pics on that to come.

View attachment DSCN4248.jpg
View attachment DSCN4249.jpg
View attachment DSCN4250.jpg
View attachment DSCN4251.jpg

This is with the panels bonded into place. Both sides are to this point.