Subframe connectors

I jacked mine up a good 2 foot off the ground and supported it at all 4 corners on stands to load the suspension. Checked the doors / trunk lid / hood windows etc... All of that checked out so I began fitting them in place using the floor jack to gently push them up into place. I don't like the installations that cut through the floor pans so I just flattened out a section of the rear floor pans in order to get the 2"x3" tubing into place and in line with the front and rear sub frame sections. End result is a little hump in rear floor pan section, but that wont be very noticeable when the carpet is installed. The ones I made fit over the rear frame sections as far back as I could go and still weld them in without welding the spring shackle brackets and I plated a 3"x5" section of the front subframe where the connector butted up. Make sure you prep the areas really well before you weld them all back up, you won't be getting back in there anytime soon!!