66 Dart GT HT Whatsitgonnabe?

Holy cow! You managed to fit an awful lot of stuff in that little (but HEAVY) box, Don!

The carb was a little beat up but nothing serious. The throttle lever and the accelerator pump lever (?) are a little bent but I'm sure they will straighten out nicely.

Seen in the picture is:
- 8 caliper pistons (7 Raybestos and 1 EIS)
- 2 brake caliper rebuild kits
- 2 brake pad retaining clip sets
- Holley 600 cfm carb
- Carb rebuild kit
- 2 dust caps for front wheel spindle bearing
- 2 grommets for PCV/breather
- 2 front brake hoses
- Windshield wiper seal kit - from Don
- 10 pcs brake bleeders
- Tank sending unit clamp ring (I only needed the gasket)
- Throttle cable holding bracket - from Don
- 1/8"NPT T-block for oil pressure switch/sender - from Don
- Ignition switch mounting ring/nut - from Don
- The little packet of goodies from Matt

HAPPY!