Oil Pan Gasket help

I do believe TB is correct IF you are putting the gaskets on the block first. Put them on the block rather than putting them on the pan as the OP shows. Use a sticky RTV to make them stick; the yellow windshield adhesive that comes in a tube will work well, 'speically for the flat gaskets along the sides.

For RTV, we always use the black stuff on pans gaskets (if inverted on the engine stand), and are not stingy with it in the corners in any installation, in-car or on the stand. Just a skim coat of RTV or adhesive is needed on the flat areas; if you use too much, it will 'grease' the cork gasket and it will more easily be crushed out of shape when you tighten the bolts and leak later.

Make sure you draw all the bolts down very evenly, and bit at a time on each all around; tighten them in 3-4 steps of gradually increasing torque, and don't over-torque.