4bt 72 Dart

From what I found a factory street Hemi weights between 690-765lb and the 4bt weights between 745-785lb so if these cars can handle the weight of the hemi, then I should be ok. I do plan on getting 1.06 torsion bars, front and rear sway bars, and tubular upper control arms. I may get those pieces of metal to box the lower control arms in as well to strength them, and I'll have polygraphite bushings, and maybe stronger strut rods. But, we will see how things go and how much everything else ends up costing. But, I'm intent is not a show car, but just a nice everyday car. So, I don't want to just dump money in it.

The height may be a problem being about 5in taller than a Hemi @32" and the 4bt @37" but I'm not sure if there including the carbs and air cleaners on the Hemi or not. Anyway I will have to figure it out.

The plan is since it is nice out today that I'm going to start on pulling the 4bt out today. One so I can get the truck out of the driveway and 2 to get it out before it gets to cold outside.