Biohazard
This post needs to be stickied if possible.
Good cheap tip, not sure I would be brave enough to hold the dash out with that much time put in it.
The pay off...
Once the plastic cools, its done. No waiting for epoxies to cure or bonds to set up.
After doing all four tabs on this particular bezel, I had to prove to myself how strong this repair really was.
Here you can see I am holding the entire instrument panel by the center cap on the gauge.
Adequate.
And so good that I scraped the epoxy bonds off all the other mounting tabs and re-did them with the 'weld' technique.
This post needs to be stickied if possible.
Good cheap tip, not sure I would be brave enough to hold the dash out with that much time put in it.
