SB to BB/clutch and flywheel options??

I just went through this. The flywheel and clutch are the same. The tti headers require their special z bar, 90 bucks. The bellpivot is specific for a body big block. The z bar still needs clearanced for the starter as it returns. I just ground a little out. The starter is a problem because it runs so close to the headers. Make sure to put a wrap on ur starter. Some guys starters get so much heat it takes a half hour to start again. All have tti's. I have a 383 and ran a mopar mini starter. With the 440 headers you may have to run a starter specified in tti directions. I believe the rods going from the z bar to pedals are the same. The fork i think is different. I went from auto to 4 speed so that one I am not sure of. Check your bellhousing. A body big block bell is the same a 65 c body big block bellhousing. The small block bells are different I believe. The bell crank pivot is specific for the bell. Hope this helps.