Factory terminals to re-pin connectors?
Some of the terminals like the TS switch, and the newer column ignition seem to be elusive.
But the flat spade terminals used in most of the terminals are known as "Packard 56." One good place I found is "clips and fasteners."
"Del City" has a lot of lot of stuff too
http://www.clipsandfasteners.com/Packard_56_Series_Male_12_Gauge_Terminals_GM_p/w32c030.htm
Be CAREFUL on the female. Some of them are GM only and don't fit the older Mopars.
The female terminals shown below will NOT fit some of the older Mopar connectors
What you DO want are the type with the sides curled over, as below:
Some of the terminals like the TS switch, and the newer column ignition seem to be elusive.
But the flat spade terminals used in most of the terminals are known as "Packard 56." One good place I found is "clips and fasteners."
"Del City" has a lot of lot of stuff too
http://www.clipsandfasteners.com/Packard_56_Series_Male_12_Gauge_Terminals_GM_p/w32c030.htm
Be CAREFUL on the female. Some of them are GM only and don't fit the older Mopars.
The female terminals shown below will NOT fit some of the older Mopar connectors
What you DO want are the type with the sides curled over, as below:
