professionaly built 340+73 dart sport parts car

I'm not sure where to start. :(
I have a professionaly built 340. I originally wanted something to run the Sebring race course. I had the dart sport and lots of plans. But the reality is i have nowhere work on it. and not enough time when i have the money and vise versa. plus my interests have changed. So after too many years i just want to see someone take over and finish it.

This is the copy from my Craigslist ad. (which is a waste of time i'm finding out.)
The bottom line is I'm selling the motor and throwing in the car. i have no use for one without the other.


340 mopar Dyno tested 500@6500. 400 ft lbs from 3600 to 6500 rpm. all roller top end with custom ground Crower "Beast cam". W2 heads were ported and polished, high flow stainless valves . Enhanced main bearing oil mod. milodon oil pan / pump with front to back pickup for braking cornering and acceleration. Mallory distributor. Was built for road course racing.
12.500$ invested THIS IS NOT A CRATE MOTOR. professionaly built by Joe Walthier and Charlie Burke at Joe's Performace. Engine is on a pallet. I can email a photocopy of the dyno results

73 dart sport; Body has some rust. needs rear fenders. Drives straight. 318 eng w 727 trans. comes with uninstalled roll cage kit, sub frames, lots of trim and interior pieces, brake and clutch pedal assb, and a-body TTI headers. Car has valid Fl title

would like to trade for low mile Volvo XC 70 wagon or $7500 takes ALL.

I will post some pictures as soon as i figure out what folder they're in.