Stalls with electrical loads

AJ/FormS said
At first glance this is an easy fix;
Tell me if I got this right;
You are running full manifold vacuum to the V-can,and
you set the initial to 14,with the V-can so hooked up,and
Then you set the idle speed to what? 650 to 700?
Then you set the mixture screws for best idle,, and
now it idles at 19inches in Neutral/Park.
And you have a stock low-stall TC

Is that correct?

So, no, this in not right.
You set the timing to 14*, and then hooked the V-can up to full-time manifold vacuum; But did not re check the idle timing after that. Then you set the idle speed to 650 to 700, and adjusted the mixture screws. It now idles at 19" in Park/Neutral. It has a 2400 TC in it.

Is this correct?