68 cuda front brake line installed pics needed

-

68vert

Well-Known Member
Joined
Nov 11, 2014
Messages
89
Reaction score
0
Location
Hot Springs AR
I have to install all new front disc brake lines on my Cuda. I meant to do it BEFORE I put the engine in , but I got too eager :banghead:
I got the car when it was taken apart and I don't have a visual on how they route around everything. I have the pre-bent lines but not sure where to begin.
Googled for pics , but really didn't find any that helps. And my shop manual isn't helpful.
Any pics , especially ones with the cross over line to passenger brake would help.
I know it's going to be a bear with the drivetrain in, but I'm not pulling it. Any suggestions would be helpful.
Thanks
 
Are you needing from the proportioning valve to the wheel? I can get a pic of my 69 tomorrow evening if that'll help.
 
I swapped 73 swinger discs onto my 69 notch. All of it pretty much 'fell' into place. I'll get you some pics after work tomorrow when i have some daylight. Heres a couple sideways pics from my phone. Probably not much help tho..
 

Attachments

  • 20150314_184234.jpg
    42.3 KB · Views: 101
  • 20150314_203748.jpg
    32.4 KB · Views: 123
here my set up
 

Attachments

  • blowercuda4.jpg
    51.2 KB · Views: 103
  • cuda 67 front disk 12 po.jpg
    40.1 KB · Views: 107
Thanks for the pic!!
Just had an aha moment !!! First time I've seen the line on the firewall. I've been thinking it went on the underside of car. This makes perfect sense now!
Have to remember this is my first Mopar...... And it's showing with basic confusion like this... Lol
Keep the pics coming....... Thanks
 
-
Back
Top