Glowing Coil Terminal

The coil doesn't have enough voltage for the electric choke. The coil has about 6v across it, and you need 12v for the choke.

Hook up the choke to the input side of the ballast resistor. Go to Napa and get a piggy back flat blade terminal and crimp it on the end of the choke positive + wire. Then put it on the ballast resistor input side and then stack the other connector on top of that.

To find the ballast input, disconnect both sides of wires from the ballast resistor and turn the key to the on position. Then clip a test light to the negative side of the battery and use the poker side to each wire for the ballast. Whichever one lights up the test light is the input. Use that one...

Then connect everything and start it up...