COP Ignition Development

BillGrissom said

There was an almost-product, termed "Rabid Gator" that was a "spark control" box for use w/ a GM 8-pin HEI module, but the guy got a better day job and no time to see it thru. I recall TrailBeast has been pinging you for a similar box, but this approach moves it up a big notch.

Click to expand...

I remember this too! too bad, looked kinda cool
https://www.yumpu.com/en/document/view/9763808/gm-hei-timingcomputerinstructionmanual-rabid-gator-


I was able to SMT solder chips with the flood method: Apply thin flux and lay very thin solder wire on top of pins, use iron to melt solder in a fluid motion across the pins. with luck, the flux keeps the solder on the pins with no bridges, if you get a bridge, just use solder wick to absorb the bridge. Its suprisingly efficient.