AlV 69 Dodge GTS project

AlV said

Thanks Mitch!

I'm very close to the end but I'm starting to stall a bit. Fixing up loose ends with the wiring. And I have to pull out the steering column to install the dash but tah should happen this weekend.

I still have to give it a systems check to make sure every thing works and finally fire.

But before I fire I think I need to install a jumper across the ballast resistor. The reason I say that is because I think that is one way to tie "ign 1" to "ign 2" for the MSD controller although I could be wrong.

Click to expand...

Looks like I'm working opposite of you. Got my GTS 383 fired up last week and broke in. Then I pulled the windshield since it was smashed from years ago. Thought I would just clean up the channel and replace all clips. But.... I dont like the paint on the dash frame. SO... Gonna pull the column and dash. See... Opposite You LOL.
Far as the jumper... I used Pertronix in my stock dist and , yes they did want me to bypass the ballast. What I did was Solder a 12ga wire behind it to keep it looking stock. It.s all in my build thread right below this.