filler neck modification

OK... for my 64 Barracuda I took a piece of 16 gauge and used a hole saw to cut a disc and filed it to be the same diameter as the inside of the filler neck. Then I drilled a hole a bit larger than an unleaded nozzle a bit closer to the bottom than centered. I filed a U shaped hole in the top which allowed me to fit it into the filler neck and serve as a vent. I positioned it squarely just below the factory vent tube. A couple of spots of welds and it's good to go. I can now insert the nozzle, squeeze the handle open and put the little lever holder in place and when it clicks off add a little bit to top it off and I'm done. No more holding the nozzle at the proper angle in the filler tube and guessing how much to squeeze the nozzle before it clicks off and repeat until frustrated. The brown you see is some gas resistant coating I got from a friend who works on airplanes to keep the washer and welds from rusting. With this mod and a Damraider cap fuel annoyance should be gone. My other early As are gonna get the filler neck mod for sure!!