my Low dollar 318 hop-up project

All was someone shitting on a posters thread trying to do a good thing. And then trashing his idea or use of a cheap part to stay within budget. Always a argued to say *** is better than your choice.

Good Lord, STFU!



Spreadbore carbs are;

TQ
Quadrajet
Holley has a couple as well.

The slight offset between the primary and secondary of the above mentioned Edelbrock carb as well as others do not make them a spreadbore carb. Split hairs if you want to.
I make this mention as not to argue but point out traditional ways of looking at the carbs.


A spread bore carburetor is any carburetor whose secondary barrels are larger than the primary. Period. That's the definition and the smaller Edelbrocks meet it. Just because you don't like it or agree with it doesn't make you right.

It does make them a spread bore, square flange carburetor. I don't really give a flip if it's splittin hairs. It's either right or wrong. you are wrong here. Thank you drive through.

Make another thread if you want to argue this. I don't want to get this sidetracked as usual.