Bitter taste of defeat! So much coolant in the oil pan.

Trevor,
When an car/truck would come into shop with engine full of shaving cream, we would pull the valve covers and intake, then wash with Kerosene with oil pan plug installed or just drop the whole pan. When you get it done and blown off with compressed air, give all the rockers and cam lobes a shot of assembly lube, fill with low buck oil then run it for 10-15 min and do another oil change with good oil. That should do it. Also, if you dont want to drop pan, leave drain plug in and bounce fender a bunch with about 2 gallons in it. Drain withing a few minutes so it cant get behind bearings on crank/rods.

Trying to get it all ouut with oil changes will take forever and cost you a case of oil. Kerosene is cheap.