Left for Dead 68 Barracuda Buildup

While I was in the polishing aluminum mood getting the thermostat housing
into shape I also polished the lid on the cool can & master cylinder relocation block.
I added a 70's sunoco 260 decal to the lid and will likely polish the entire can eventually.
The handle is a drawer pull I slid a piece of fuel line on.
This cool can came with a 3/8" coiled aluminum tube. I'm thinking I should have 1/2" and will see if I can up the size a bit.
I do the polishing while I am digging up or waiting on the next missing part needed to
move ahead. Alternator spacers are holding me up now that the fan is in place. Need 3 but I haven't measured for length yet. When I have the measuments I will order some I seen on eBay as they are cheaper than making them myself. Will order enough 1/2" aluminum fuel line to go front to back at the same time to get a start on the fuel system.
The master cylinder is still uncertain at this point. If I can find a vintage Hurst Airheart
aluminum job I will use it to save some weight. If not I will have the iron one chrome
plated.