flexplate install

OP...........

1....You need to post the part no of your flexplate. Much of this could have been averted if you'd posted that first

2....IF that is the correct plate, it is for a FACTORY balanced/ weighted 360 to use a neutral balance converter, such as 340/ 318

3...Do NOT remove the "small squares" with the bolt holes. Remove any other weights from the converter

4....Mark the flex/ converter FIRST. One bolt hole is "offset" so that it only bolts up one way. You CAN assemble the engine / trans, and "try" all 4 positions but that is a PITA