Duels out in front of rear wheels

Like this maybe?
I bought the pipe and had the shop 45 the ends, and cut them off at the exact angles I needed back at the house.

The pipes crossed on the stand are tacked and ready for welding up and the two ends closest together go on the mufflers.
The other ends were left long until I got that section fitted to the mufflers so I could see where to cut them.

Where they went under the subframe connectors I sliced them and angled them up a little on the ends, and they are bologna cut on the ends to the same line as the car body.
(meaning looking down from the top of the fender the ends follow the same angle as the body.

I welded J hangars that I made from 5/16 rod to the top edge of the subframe connectors and to the pipes so I could use the type of rubber hangar you see below.

Oh, and it was all gas bottle tig welded.
And yes, the pipes totally cross through each other for reverberation dampening.
It sounds mean as hell for a basically stock block 318. :D