Zac_F71's 71 Demon

Small update! Got most of the cash to pay off the motor, got the Demon carb rebuilt(need a couple more fittings here), and started in on setting up the 3.73 gears.. pinion and ring gear installed last night, just have to set the backlash/ wear pattern, and it's good to go..

Found the reason the car was so high in the back end, and bouncier than it shoulda been as well.. the Mopar adjustable pinion snubber was sitting on the floor holding the car up.. ended up elongating the bottom holes in it as it wouldn't sit in the bottom.. will be test fitting it here mid April as I really am focusing on paying the motor off..

Got another parts order in the works as well -

Summit cast aluminum deep trans pan
2 qts Royal Purple 75/90
1 bottle of Ford friction modifier
Felpro center section gasket
Summit 45*, and 90* -6 AN fittings