70 Duster power window install

Pic. 1,2, I needed a place for the stop bolt to mount and this is were I chose, red circled.
Pic. 3 I tried to keep the hole in line with the center gear pivot and spring catch.
Pic. 4 I measured 9/16" off spring catch rivet (3/4" on center) and drilled 5/16" hole. I ground the top of rounded stop bolt as it was a bit to thick to move freely through regulator. I also had to grind a little off the reg, Blue line in pic 2.
Pic. 5 To find were my stop bolt would ride I bolted the right reg to the outside left door and used the 5/16" hole to scribe a tracking line. ( Green arrow) Do the same to opposite door.
Pic. 6 I then put it all together including window and lifted window to the top. I measured stop bolt on inside of door and transferred on outside.
Pic. 7 Circle is were stop bolt is located.
Pic.8 This is were the cam bolt will be. Mark and drill hole. Now take it all apart, install cam bolt and put it all back together.
Pic. 9 Cam bolt installed, now you can adjust so all the stress is on cam bolt and not on plastic window stops.
You are now ready to wire it up.
There is no welding to do with this conversion, just drilling 5 holes. You can go back to manual windows latter if you want.
Mike