Wanting 500 hp (or close) out of a stock stroke 360
listen to RAMM, he know what it takes to get there:burnout:
according to pipemax and Larry meaux, this Hughescam is done at 6000.
the intake lobe is rated at 5500rpm, and exhaust a bit higher.
also, the time the valve is open (duration+lift) also limits the powerband to about 6k
on the other side, I dont know if its possible at 6k(I dont have run that many engines in the dyno), but if you reach a VE on 105%, pipemax estimate 460hp on a good tune on this camshaft. so built correctly you have a really strong engine!
[/URL][/IMG]
good luck!
listen to RAMM, he know what it takes to get there:burnout:
according to pipemax and Larry meaux, this Hughescam is done at 6000.
the intake lobe is rated at 5500rpm, and exhaust a bit higher.
also, the time the valve is open (duration+lift) also limits the powerband to about 6k
on the other side, I dont know if its possible at 6k(I dont have run that many engines in the dyno), but if you reach a VE on 105%, pipemax estimate 460hp on a good tune on this camshaft. so built correctly you have a really strong engine!
[/URL][/IMG]good luck!
