Stainless exhaust tips

-
Nite Moves

Nite Moves

Well-Known Member
Joined
Dec 2, 2010
Messages
3,653
Reaction score
154
Location
Belleville,ontario,canada
Good day everyone.I recently got my exhaust done and its duals out the back. Im woundering what you all have for tips. 2 1/4 pipe out back and i want to put on some nice S/S tips. I like the rolled ends but im looking for some insight and pics to decide. 3inch to maybe 4inch round out back.....The shop gave me lots of pipe out back to do what i want. Any ideas? As always,thanks in advance, N.M
 
A few pics of what i have now. Sorry for the pics but not alot of room in the garage
 

Attachments

  • IMG_0488.jpg
    38.4 KB · Views: 520
  • IMG_0489.jpg
    34.4 KB · Views: 507
  • IMG_0490.jpg
    40.8 KB · Views: 504
I like the slotted tips on the later Road Runners and Chargers. They wouldn't be "correct" but I think they are cool.
 
Try these ol buddy. lol
 

Attachments

  • CHEVY TIPS.jpg
    8.1 KB · Views: 472
I am running the TTi factory tips on my '69.

[ame="https://www.youtube.com/watch?v=kpOahpC6zJM"]New idle - YouTube[/ame]
 
vbpgimage.php
 
I like to run ovalized megaphones on my stuff. They are about a foot long, 5" wide and about 2 inches tall at the opening. They enhance the sound in a way similar to the flare enhances the sound of trumpets etc.
 
Post #6 the best...rofl..my stomach is killing me. Haha
:finga:
 
Mguner your exhaust tips are nice...That goes with your wicked nice car.:finga:
 
Well i just ordered a pair of s/s round tips at 12 inches long and 3 1/2 o.d. Rolled edge with slant cut. Should be here friday. Will post a few pics. Thanks for the insight all!
 
I went with 3 1/2 o.d , Rolled edge. MBRP got a good deal on them. Think they look good.
 

Attachments

  • IMG_0510.jpg
    44.1 KB · Views: 237
  • IMG_0511.jpg
    43.8 KB · Views: 226
  • IMG_0512.jpg
    39.1 KB · Views: 220
  • IMG_0513.jpg
    38.5 KB · Views: 220
Believe it or not, Amazon.ca $34 each free shipping. I think they sit a bit low, maybe nicer if they were closer to the bottom lip of bumper?????????
 
Because of the back up lights in the bumper. I would go with "pipe diameter weld on turn downs". I think it would also look correct, If that car would have came with dual exhaust.
 
You must log in or register to reply here.
-

Back
Top