318 hydraulic lifter preload.

After removing the heads and inspecting the bores again, I'm not satisfied with the bores. Ridge reamer cut to low into the cylinder and is in the area where the rings travel. It will not seal and I'll have to pull this back out to fix it. So, I'm doing a complete rebuild and that's not what I wanted to do. Heads are at the shop being checked over and having .010 taken off. KB pistons on order,. 028 head gasket on order. I checked the block and its out no more than .0015. The upside, this build should last a good long time and make for a fun street rod and isn't going to cost me as much as building a 360. If I were building a 360 I would be throwing more money at it than the 318. Keeping in mind, I don't have a 360 sitting here, I do have the 318 sitting here.