Some 5.9 roller cam help from y'all please

Like I said, OUR springs are no cutting required, direct fit, 120# @1.66 and 300#@1.16. Capable of at least .575", actually higher but any higher and you will want to move up to something like 200#1.88 with a longer valve to keep rocker geometry under control.

In your case, EQ heads will handle LOTS of lift with the correct custom retainers, springs and locks, which we happen to have in stock. I stand behind my original cam recommendation as well....do it once, do it right.

Dont know where you got EQ's but when we sell them, they come with PEP 80#@1.60 factory spec springs and will work great up to about .450" lift. Our Stage II EQ's come with the upgraded springs I mentioned, good for .575" lift.

If you got EQ's from Jegs, you got chinese factory spec springs and you paid too much :D



Ok, you have my attention because now it feels like I am getting some real specific information.
Actually, after reading back through every post most of the information was there but I apparently didn't really see it because it was so spread out through the thread.
My apologies on that. (must have been a bit frustrating for you) :D

I would need to ask again about the idle light lope I would like.
Can that be done, and can you do it?
If so, shoot me an estimate and list of the parts needed for the "up to 575 lift springs, retainers, locks if I need new ones and the cam please if you don't mind.

If for some reason you can't do the idle then I will have to go with the other cam, but I can still use your springs and, retainers and locks.


I have not committed to anyone or ordered any of this yet.

Thank you for the patience and persistence in getting it through my head.

I have to go now for the night, but please shoot me that info if you could.