Electronic ignition conversion need help!

CG65Dart270 said
Thanks, both of you! Trailbeast I'm not quite sure what the best route for me to go would be. I have the OEM distributor that came with this engine. I just need the proper parts to make it work. I'm kinda flying blind as to what I need at all. This is the first conversion I've done. As for cost I am trying to keep it as low as possible but I'm not delusional lol. Restoring a car ain't cheap.

Well in my own opinion (and I'm sure I won't be the only one) this is the perfect time to HEI that bad boy since it's all up in the air as far as wiring anyway.
The HEI kits are WAY easier and cleaner to wire up and you end up with a good strong ignition system that is super reliable and easy as pie to get a replacement part for if you ever needed it.
A new stereo is a lot harder than the HEI kits are to install.

You could even run a modified or aftermarket distributor with it later if you chose to do so, but your existing electronic would work great with it as well until then.

Alternatively you could get a Skip White "Ready to Run" HEI distributor for about 60 bucks or so shipped and have HEI really cheap that uses a single wire to run the entire ignition system.
(No box, ballast or harness crap to mess with)
Google those also and check it out as a lot of people have been pretty happy with those.

If you are not pushed for time do some searching and google-ing on HEI for Mopars and get some more information on it first.

RustyRatRod said
Shut up stupid. Fore I change my mind. lol

LOL