1967 Cuda FB project

Well, studying the piece I made, decided it was ending too abrupt. The front slowly blends in with the fender so I decided that the back should too. Started over. Made a new "spear" and fit it the full length of the q-panel. Then cut off the bottom of the quarter cuz it has to be made taller. Made a new piece for the quarter bottom, and this is what came out. Much cleaner and drops the quarter to balance out the car.
View attachment WP_20160424_001.jpg
View attachment WP_20160424_002.jpg
View attachment WP_20160424_003.jpg
View attachment WP_20160424_005.jpg

Now to do the other side and make the rear roll pan. Still don't think it's deep enough to make holes for the exhaust tho.

:burnout: