What did I do wrong?

Doctor Diff Gears Marked for .095.

That is what I started at (.094) and thought it was real close with minor backlash change. What most surprised me after installing the real bearing of the same manufacture that it was contacting the center section. Thought I would save some effort and learn a new trick with the freeze/heat method. It seemed to be so easy!!! Not happy on final assembly though! Pressed off the bearing and will not re-use it even though it looks fine. Dropped the pack down to .084 and have basically the same pattern. Is this enough for heat expansion??? I am a concerned! I have a new bearing ready to go but do not want to do this again!!