Finally dyno'd my 383!

crackedback said
Very cool. Nice engine build

Your torque peak should be below 5500, maybe in the 4000-4500 range. Can you get a sheet with your best run?

Thanks! I reused the cam from the previous build with the same motor (dropped a valve), it is on the smaller side, but at the time the money just wasn't there while doing the rebuild as I was swapping to 3.73's, looking for 1.6 roller rockers, and a few other parts.. maybe next fall I will swap cams to a little better one.. but for now my Dad and I are going to enjoy the s+-t out of this car!

Peak torque was in that range yes, peak hp was in the 5,500 - 5,800 or so range

torque at 3,000 was 425ft lbs or so, like I said with a very nice torque curve..