RMS in a 68 Barracuda, oil pan problems

Ok I went and installed the 416 in my Barracuda. Ran into a problem right off. I have a Milodon #30935 oil pan on it that is 8 3/4" deep. the pass front corner hits the rack and pinion mouting bolt, BAD, not just a little. Doesn't allow the back of the engine to be lowered where it needs to be. I call and talk to Bill at RMS, ask which pan do I need, he tells me he's not heard of any Milodon pan not working? Oh lucky me! They do make a #30936 that is 7 3/4" deep, one inch less than the one I have., though I don't think it is enough to clear the rack mounting bolt. Now there are enough of these out there that someone should be able to answer my question. Bill did say he was sending 4 RMS suspensions to Milodon so they can design a different pan. I guess I'm not the only one?