Removing Steering Shaft 1966 Barracuda
Thanks to your recommendations it was simple to get that exhaust manifold in place.
The roll pin was easy to remove. Just wacked it out with a iron rod and hammer. It doesn't matter what side you start. The pin is straight. Did mark the spline position with a white marker, before removing the bracket of the steering column. It slid out like butter. Thanks a lot.
Turning the shaft in position
Hammering the roller pin out
The pin removed with the iron rod
Installing manifold
Getting ready to put it in again (see white marks)
Pin installed (white marks in correct position again)
not much space on driver's side.
These pictures go on my restoration thread "1966 Barracuda car ****" as well 8 ))
Thanks to your recommendations it was simple to get that exhaust manifold in place.
The roll pin was easy to remove. Just wacked it out with a iron rod and hammer. It doesn't matter what side you start. The pin is straight. Did mark the spline position with a white marker, before removing the bracket of the steering column. It slid out like butter. Thanks a lot.
Turning the shaft in position
Hammering the roller pin out
The pin removed with the iron rod
Installing manifold
Getting ready to put it in again (see white marks)
Pin installed (white marks in correct position again)
not much space on driver's side.
These pictures go on my restoration thread "1966 Barracuda car ****" as well 8 ))