Foose 17x8 4.5 bs on 67 Dart ?
Then you should run these. :D
https://www.summitracing.com/parts/mtt-2989422/overview/
They're 18x9's with a 6.25" backspace. You could run them with 245/40/18's. In the front you wouldn't need anything, they should be fine (I run 275's with almost exactly the same offset). In the back you'll have to run a 1" spacer/adaptor, like this- 1" 5x114.3 Hubcentric Wheel Spacers Mustang GT500 Shelby Cobra SVT GT | 1.0 inch
It will be tight in the back, most of those cars have ~11" from the springs to the quarters, and a 9" wide rim is actually 10" wide outside to outside (the 9" measurement is where the tire mounts on the inside lip). So before you did that I would measure that you actually have about 11" from the inside of the quarter lip to the springs. But with the 6.25" backspace, 1" spacer, and rear disk that should end up where in needs to be. Body tolerances on these cars vary a bit, so it pays to measure a couple times before you buy anything when you start getting down to the minimum clearances.
Then you should run these. :D
https://www.summitracing.com/parts/mtt-2989422/overview/
They're 18x9's with a 6.25" backspace. You could run them with 245/40/18's. In the front you wouldn't need anything, they should be fine (I run 275's with almost exactly the same offset). In the back you'll have to run a 1" spacer/adaptor, like this- 1" 5x114.3 Hubcentric Wheel Spacers Mustang GT500 Shelby Cobra SVT GT | 1.0 inch
It will be tight in the back, most of those cars have ~11" from the springs to the quarters, and a 9" wide rim is actually 10" wide outside to outside (the 9" measurement is where the tire mounts on the inside lip). So before you did that I would measure that you actually have about 11" from the inside of the quarter lip to the springs. But with the 6.25" backspace, 1" spacer, and rear disk that should end up where in needs to be. Body tolerances on these cars vary a bit, so it pays to measure a couple times before you buy anything when you start getting down to the minimum clearances.
