New Harness Connection

-
MrJLR

MrJLR

Built, not bought
FABO Gold Member
Joined
May 14, 2015
Messages
5,619
Reaction score
6,712
Location
Menifee, California
Ok, I'm ready to plug in my new harness under the hood of my 68 Cuda.
Just help verify which plug goes where.....
here is the new connection from inside .....

20160722_143741_zps2naypqzo.jpg


And here are the new connectors on the harness...

20160722_143845_zpsamj7l1lu.jpg


Which one goes in which hole?



I'm getting close to breaking in the cam!

20160722_113105_zpsyrjhymml.jpg


Jeff
 
They are keyed so they only go in the proper slot...

Just match them up with the key/slot on the side and you will figure it out...
 
krazykuda said:
They are keyed so they only go in the proper slot...

Just match them up with the key/slot on the side and you will figure it out...
Click to expand...
Damn....I didn't realize that. ...I'll go take a closer look!

Thanks!

Jeff
 
Wiper harness on the driver's side...

Engine harness goes to the center...

Front end lighting goes on the pass side....
 
Lol....damn....I didn't notice the big obvious keys on them....thanks again....
They're plugged in. ...

Jeff
 
MrJLR said:
Lol....damn....I didn't notice the big obvious keys on them....thanks again....
They're plugged in. ...

Jeff
Click to expand...


Good deal... :thumbsup:

I've wired a couple of a-body engine compartments in the past few months... :mad:

I'm a little intimate with the wires and harnesses.... :BangHead: :BangHead: :BangHead:
 
krazykuda said:
Good deal... :thumbsup:

I've wired a couple of a-body engine compartments in the past few months... :mad:

I'm a little intimate with the wires and harnesses.... :BangHead: :BangHead: :BangHead:
Click to expand...
I might be asking a few more questions here in the near future!

Jeff
 
Not trying to be a dick, but any re-wire attempt should always start with a good understanding of the task at hand by reviewing the factory wiring doc's.

They will clearly show you the bulkhead connectors are keyed. Keep this for future reference it will serve you well.

Glad you are on the right track!!
 

Attachments

  • 68 Barracuda Factory Wiring REV 2.pdf
    120 KB · Views: 83
1969383S said:
Not trying to be a dick, but any re-wire attempt should always start with a good understanding of the task at hand by reviewing the factory wiring doc's.

They will clearly show you the bulkhead connectors are keyed. Keep this for future reference it will serve you well.

Glad you are on the right track!!
Click to expand...

I've never let that stop me before :thumbsup:

By the way, great diagram -thanks!
 
MrJLR said:
I've never let that stop me before :thumbsup:

By the way, great diagram -thanks!
Click to expand...

My pleasure, I have posted these many times and there may be some human error creating them! They are re-traced from originals but if you find an error please return some feedback! Also you can Turn the layers on and off with the eyeball feature in Adobe to isolate different circuits.
 
You must log in or register to reply here.
-

Back
Top