Built 318 with Edelbrock RPM combo
I have a 318 that has been built. Bored .060, crank .010/.010. 10.25/1 pistons, balanced and has Edelbrock RPM heads/ intake. Has MSD distributor and wires. Runs am Erson tq-40 cam that has 220*intake/230*exhaust duration. has 1.6 roller rockers that has .515 lift. All fastners are new, head studs. I was told it made just over 400hp on the dyno, but don't have the dyno sheet. I have most of the supporting doccuments from the builder and the parts that were purchased for it. It is a new engine that has only been run on the dyno from the builder.
I was going to use his motor in the Duster, but decided to rebuild a numbers matching 340 for the car instead. I cannot ship the engine. Located in Milford, De. 19963
asking $4,500 obo
I have a 318 that has been built. Bored .060, crank .010/.010. 10.25/1 pistons, balanced and has Edelbrock RPM heads/ intake. Has MSD distributor and wires. Runs am Erson tq-40 cam that has 220*intake/230*exhaust duration. has 1.6 roller rockers that has .515 lift. All fastners are new, head studs. I was told it made just over 400hp on the dyno, but don't have the dyno sheet. I have most of the supporting doccuments from the builder and the parts that were purchased for it. It is a new engine that has only been run on the dyno from the builder.
I was going to use his motor in the Duster, but decided to rebuild a numbers matching 340 for the car instead. I cannot ship the engine. Located in Milford, De. 19963
asking $4,500 obo
