Rebuilt 340
This started as a bare 2-70 standard bore block. Now .020 over.
It was square decked and align honed. Bores were machined and honed with a deck plate.
It has a neutral balanced cast SCAT 3.58 stroke crank, with Eagle H- beam rods and K-B 107 .60 over pistons.
Comp Cams XE274H hydraulic cam, lifters, and pushrods.
Mancini adjustable rockers.
Edelbrock heads.
Weiand Stealth intake.
Holley 750 vacuum secondary carb.
Firecore distributor.
ARP fasteners used through out the engine.
Stock 340 oil pan.
I ran this for about 100 miles in my Dart before I sold it. I had stock X heads on it until some one offered to buy them. It now as the Edelbrocks.
Compression is approx. 10.2 to 1.
It has been on the run stand for a while now and I have had the engine apart several times to swap the heads etc. Hence it shows some wear. Internally it is still new.
You can hear it run if you stop by Tehachapi in your travels.
I have receipts for every thing here and can show where all work was done.
I'm asking $3800 as it sits. Carb to pan.
I'm in Tehachapi, Ca. 93561 and am willing to ship to the lower 48 if you pay freight costs.
PM me here with any questions.
This started as a bare 2-70 standard bore block. Now .020 over.
It was square decked and align honed. Bores were machined and honed with a deck plate.
It has a neutral balanced cast SCAT 3.58 stroke crank, with Eagle H- beam rods and K-B 107 .60 over pistons.
Comp Cams XE274H hydraulic cam, lifters, and pushrods.
Mancini adjustable rockers.
Edelbrock heads.
Weiand Stealth intake.
Holley 750 vacuum secondary carb.
Firecore distributor.
ARP fasteners used through out the engine.
Stock 340 oil pan.
I ran this for about 100 miles in my Dart before I sold it. I had stock X heads on it until some one offered to buy them. It now as the Edelbrocks.
Compression is approx. 10.2 to 1.
It has been on the run stand for a while now and I have had the engine apart several times to swap the heads etc. Hence it shows some wear. Internally it is still new.
You can hear it run if you stop by Tehachapi in your travels.
I have receipts for every thing here and can show where all work was done.
I'm asking $3800 as it sits. Carb to pan.
I'm in Tehachapi, Ca. 93561 and am willing to ship to the lower 48 if you pay freight costs.
PM me here with any questions.
