Prw stainless rockers
I have new LA-X heads and new 1622-16 Comp Ultra Magnum 1.5 shaft rockers that use ball/ball pushrods and the geometry is almost perfect. The roller is about .020" offset to the outer side of the valve and about .040 sweep from 0-.500" of lift and they would still work great at .650" of lift also, with about .060" of sweep. The pushrod angle to adjuster is correct also. This is based on what the B3 racing engines site shows for proper geometry.
I had an AutoZone 30% off discount code I used, they only cost $400.00 this way. I scored some coated Doug's D453 header for $429.00 also that day.
I have new LA-X heads and new 1622-16 Comp Ultra Magnum 1.5 shaft rockers that use ball/ball pushrods and the geometry is almost perfect. The roller is about .020" offset to the outer side of the valve and about .040 sweep from 0-.500" of lift and they would still work great at .650" of lift also, with about .060" of sweep. The pushrod angle to adjuster is correct also. This is based on what the B3 racing engines site shows for proper geometry.
I had an AutoZone 30% off discount code I used, they only cost $400.00 this way. I scored some coated Doug's D453 header for $429.00 also that day.
