TTI BB headers...in an A-body?? Tell me your story...
Here is a video of my old dart after I just got done installing a 3.5 inch exhaust system on it. It was a Indy headed 440 with the Tati headers. The exhaust pipes was a home made kit.
On my car I had to take the grease zerk out of the pitman arm, was runing one of the tubes. Had to cut the shift lever off the steering column. Other than that I didn't have to dent any of the tubes. Also don't install the 7/16 mounting bolt for the trans. I am talking about the two bolts that go into the trans from the engine side. There is one on each side at the bottom of the engine/ transmission. You can't the bolt out after the headers are bolted on, on the passengers side. Here is a short vid I made after I got the exhaust pipes put on. The mufflers are 3.5 inch dynomax bullets.