American AutoWire
sorry I haven't updated this. Still not 100% complete with the install as i've been in and out of the country with work. Dash harness, engine, and front light harness is in, just need to finish up the rear body harness. I am very impressed with this harness. Every single thing you need is there**. The instructions are very clear and the install is very easy and going smooth. Very easy to customize this harness to suit your individual needs as well. I would def purchase it again. Once the harness is fully installed and I get some miles on it to validate no bugs, I will pull it out to do the final dress up with mini-zipties, F6 covering, dielectric greas, silicone up the bulkhead, etc. I'll post some pics then, or pics of anything specific y'all request to see. Honestly my hats off to guys that can do a project and document it well with detailed pics. I barely have the time to do the work, much less take pics!
**this harness is designed to be ran with a 1-wire alternator. It has no provision to run a stock alt with external VR, or 3-wire Denso with internal VR. I just used extra wire from the kit(VSS wiring) and ran a sense wire from the starter solenoid stud, and used the keyed 12v for the electric choke as the excite wire.
With a 70amp Denso I'm seeing 14.3v from idle to 6k . After speaking with AAW they are aware there is a strong desire to run the 3-wire Denso and are looking at altering future harnesses for this. Regardless it would be easy to retrofit it to add the simple circuit for the excite wire if you need to retain the electric choke..
